HYDROSTATION
Hydrostation is the new IE5 efficiency class electronic system for constant pressure…
AISI 304 stainless steel submersible pump and single-channel impeller (DW) or vortex impeller (DW VOX) for fixed and mobile installations. Available with two versions for piping connection. Suitable for domestic applications and large industrial wastewater lifting installations. Read more
Flow rate | up to 54 m³/h for DW up to 48 m³/h for DW VOX |
Total head | up to 20 m for DW up to 15.7 m for DW VOX |
Max. temperature of the liquid | +40°C |
Poles | 2 |
Max. solids passage | 50 mm |
Insulation class | F |
Protection degree | IPX8 |
Voltage | Single-phase 1~230V ± 10% Three-phase 3~400V ±10% |
Max. immersion | 7 m with 10 m cable |
Pump body | Stainless steel AISI 304 (EN 1.4301) |
Impeller | Stainless steel AISI 304 (EN 1.4301) |
Shaft | Stainless steel AISI 303 (EN 1.4305) (part in contact with liquid) |
Mechanical seal | upper part in Carbon/Ceramic/NBR (motor side) lower part in Silicon Carbide/NBR (pump side) |
Can I extend/replace the power cord without causing technical problems or affecting the warranty?
Yes, anyhow this operation has to be carried out by a specialised technician or at an authorised EBARA Service Centre. This avoids improper connections that can adversely affect the pump’s correct operation and/or the safety of the installation.
What should the dimensions of the handhole where I’m inserting the pump be?
It depends on the pump’s type and model.
Strictly follow the directions provided in the instruction manual.
What is the minimum amount of liquid that the pump must be submerged in?
Strictly follow the directions provided in the instruction manual.
How can I adjust the float switch in order to avoid problems when starting or stopping?
If the pump is fitted with a float switch, the latter must have enough room to move freely, so that it can switch and ensure a proper pump operation.
Please follow the directions provided in the instruction manual when the installation requires float switches that are fixed to the tank and are driven by a distribution board.
Contact us
* Required