HYDROSTATION
Hydrostation is the new IE5 efficiency class electronic system for constant pressure…
Submersible pump with semi-open impeller with cast iron shim and anti-clogging filters, supplied as standard with the thermal protector and double mechanical seal with oil chamber. Suitable for pumping clear water and rainwater. Read more
Flow rate | up to 84 m³/h |
Total head | up to 43 m |
Max. temperature of the liquid | +40°C |
Poles | 2 |
Max. solids passage | 5 mm (50DS) 6 mm (65DS) (40DSF 1.5, 1.9 kW) 7 mm (80DS) (40DSF 6 kW) 8 mm (100DS) |
Insulation class | F for DS H for DSF |
Protection degree | IP68 |
Voltage | Three-phase 3~380-415±10% (DS) Single-phase 1~230±10% (DSF) Three-phase 3~400/690±10% (DSF) |
Max. immersion | up to 1.5kW: 3 m with 6 m cable over 1.5kW: 7 m with 10 m cable |
Max. length of fibres | 50 mm |
Pump body | Cast iron |
Impeller | Cast iron |
Shaft | Stainless steel AISI 403 (EN 1.4006) (DS) Stainless steel AISI 420B (EN 1.4028) (DSF) |
Mechanical seal | Impeller side: Silicon Carbide/NBR Motor side: Carbon/Ceramic/NBR (6 kW and above for DSF) |
How can I adjust the float switch in order to avoid problems when starting or stopping?
If the pump is fitted with a float switch, the latter must have enough room to move freely, so that it can switch and ensure a proper pump operation.
Please follow the directions provided in the instruction manual when the installation requires float switches that are fixed to the tank and are driven by a distribution board.
What is the minimum amount of liquid that the pump must be submerged in?
Strictly follow the directions provided in the instruction manual.
What should the dimensions of the handhole where I’m inserting the pump be?
It depends on the pump’s type and model.
Strictly follow the directions provided in the instruction manual.
Contact us
* Required