HYDROSTATION
Hydrostation is the new IE5 efficiency class electronic system for constant pressure…
Cast iron submersible pump with open two-channel impeller and semi-open anti-clogging impeller. It has a wide range of powers up to 45 kW and different discharge diameters. Suitable for pumping wastewater with suspended solid and fibrous bodies. Read more
Flow rate | up to 780 m³/h |
Total head | up to 43.5 m |
Max. temperature of the liquid | +40°C |
Poles | 4 |
Max. solids passage | 35 mm (65DL) 50 mm (80DL, all DLC) 60 mm (100DL, 100DLB) 70 mm (150DL up to 22 kW) 76 mm (200DL up to 22 kW) 76 mm (all 30÷44 kW) 82 mm (250DL up to 22 kW) 90 mm (300DL up to 22 kW) |
Insulation class | F |
Protection degree | IP68 |
Voltage | Three-phase 3~380-415±10% (1.5÷7.5kW) Three-phase 3~400-415±10% (starting Δ 11÷22kW) Three-phase 3~380-415±10% (starting Δ 30÷45kW) |
Max. immersion | 7 m with 10 m cable |
Max. length of fibres | 195 mm (65DL) 240 mm (80DL, all DLC) 300 mm (100DL, 100DLB) 400 mm (150DL up to 22 kW) 500 mm (200DL up to 22 kW) 500 mm (all 30÷44 kW) 550 mm (250DL up to 22 kW) 600 mm (300DL up to 22 kW) |
Pump body | Cast iron |
Impeller | Cast iron |
Shaft | Stainless steel AISI 403 (EN 1.4006) |
Mechanical seal | Impeller side: Silicon carbide/Silicon carbide/NBR Motor side: Carbon/Ceramic/NBR |
Can I extend/replace the power cord without causing technical problems or affecting the warranty?
Yes, anyhow this operation has to be carried out by a specialised technician or at an authorised EBARA Service Centre. This avoids improper connections that can adversely affect the pump’s correct operation and/or the safety of the installation.
What should the dimensions of the handhole where I’m inserting the pump be?
It depends on the pump’s type and model.
Strictly follow the directions provided in the instruction manual.
What is the minimum amount of liquid that the pump must be submerged in?
Strictly follow the directions provided in the instruction manual.
How can I adjust the float switch in order to avoid problems when starting or stopping?
If the pump is fitted with a float switch, the latter must have enough room to move freely, so that it can switch and ensure a proper pump operation.
Please follow the directions provided in the instruction manual when the installation requires float switches that are fixed to the tank and are driven by a distribution board.
Contact us
* Required